Marcelino Martinez_Sober⁽¹⁾, Juan Guerrero⁽²⁾, Gustavo Camps i Valls⁽³⁾, Antonio J. Serrano López⁽⁴⁾, José David Martín Guerrero^(5)
(1)Universidad de Valencia - Burjassot. Spain
⁽²⁾Departamento de Electrónica. Universidad de Valencia - Burjassot. Spain
⁽³⁾Universitat de València - Burjassot, Valencia. Spain
⁽⁴⁾Dpto. Electrónica. Universidad de Valencia - Burjasot. Spain
⁽⁵⁾G.P.D.S. Departament d´Enginyeria Electrònica. Universitat de València - Burjassot. Spain

	[Cardiolovascular Diseases]	[Health Informatics]

IMAGES

Figure 1. Holter tape digitalisation equipment.

Figura 2. Process of marking fiducial points.

Figure 3. Series RR of 24 hours (superior) in the one that the considered daily and nocturne periods are shown. In the lower part of the figure, a detail view of the signal period is shown and the complex QRS has been marked located by the detector.

Figura 4. Example of elimination of non-valid tracts and of echtopics. Interpolation method: lineal.

Table I. Example of parameters calculated for a RR time series.

Discussion Board

Any Comment to this presentation?

[ABSTRACT] [INTRODUCTION] [DIGITALISATION AND TIME SERIES OBTENTION] [TIME SERIES PROCESSING] [IMAGES] [CONCLUSIONS] [ACKNOWLEDGEMENTS] [BIBLIOGRAPHY] [Discussion Board]

---

	[Cardiolovascular Diseases]	[Health Informatics]

Marcelino Martinez_Sober, Juan Guerrero, Gustavo Camps i Valls, Antonio J. Serrano López, José David Martín Guerrero
Copyright © 1999-2000. All rights reserved.

Last update: 14/01/00